============================================================================= My girlfriend and I have both enjoy a lot of bondage mixed with our sex.============================================================================= My girlfriend and I have both enjoy a lot of bondage mixed with our sex. Recently we've added tickling as one of the torments we use on one another. We each find it very exciting to tie the other down and explore our lovers ticklish areas while she thrashes frantically against her bonds. I've discovered that my lovers feet and the sides and underside of her breasts are her most ticklish areas. She usually comes from the tickling alone but her orgasms are much more intense if I fuck her with a dildo while I tickle her. Lately we have been trying to out do each other in coming up with devious bondage positions and tortures. The following is both a story about a torture I used on her and a plea for new and original ideas. Drawing on my experiences with a rather devious torture that a lover of mine used on me several years ago, I set about designing and building a new bondage device for use on my girlfriend. I started with a wooden bar stool (four legs, wooden top), first I cut two circular notches out of the edge of the top so that a person could sit in the center of the stool (with one of the stool legs in front of them) and their legs would extend straight down to the floor. Next I drilled a hole in the center of the stool wide enough to accept my 10" dildo and still have room to be lined with leather. I glued foam to the top of the stool then covered it with leather (actually fake leather) and extended the cover down into the center hole. I now had a stool with a sculpted padded leather top with an ominous hole in the center. Next I glued two short pieces of wood (1" x 1" x 6") on opposite sides of the hole on the bottom of the stool then I drilled a 1/4" hole through both of them across the hole in the stool. In order to make the stool more stable I screwed the legs to a 3' square piece of plywood. The final step was to drill a 1/4" hole through the base of my 10" dildo. |